Replacing A Ceiling Fan And Light With Just A Light

By emrah oruc updated december 09 2018 an outdated ceiling fan can be replaced with a modern light fixture to give a room a fresh look. Just got a fanlight combo as a replacement for a fan only setup in existing junction box and utilize a lutron light and fan combo switch instead of a simple onoff switch that was last there with the old setup.

Replace Your Ceiling Fan With A Better Looking One Robb Restyle

Replacing a ceiling fan and light with just a light. I would like to replace it with a plain light fixture if it is not too hard to get the wiring into a safe configuration. Place the base of the light fixture over the electrical box in the ceiling aligning the holes on the light fixture with the holes on the electrical box. I have a ceiling fan with separate fan speed control and switch on the wall. Replacing a ceiling fan light with a regular light fixture by cliff popejoy tim healey when changing a fanlight to a light fixture cap off the unused wire at both ends. If your fan includes a light fixture assemble the fixture and switch housing if provided then attach the fixture to the fan motor assembly. The old fixture which she had already removed was controlled by two light switches and a variable speed fan control.

I have been thinking of replacing a light fixture in my bedroom ceiling with a ceiling fani have been reading that some people replace the smaller junction box in the ceiling with a bigger one to compensate for the extra weight and vibration of the ceiling fan. Connect the wiring according to the manufacturers instructions. The ceiling fixture has a black red white and ground. Been a while since i removed the old stuff so now lost on how to make it all work. Insert the included screws and tighten them. Because most ceiling fans are heavier than the average light.

It is wired to a switch and fan speed control as follows. Install the glass dome or decorative light shades and bulbs. The light switches are at each end of the room so a three way circuit is in place and the fan control is boxed in a two gang with one of the toggle light switches.