If you have successfully set up your compatible hub but cannot get a connected cree led bulb to pair with the hub in the applicable app you can factory reset your bulbs. I could pair my 4 other bulbs without any problem.
Smart Bulb Flashing And Flickering Causes Amp Fixes
Cree connected bulb reset. I tried doing a full reset on my hubitat and starting over. Starting with the. Turned on cree bulb. Make sure the bulb is installed and turned on in the smartthings app tap my home turn the bulb off for 2 seconds and then turn it on for 1 second. It will only dim for a second signaling that it has been factory reset. Try a manual reset belkin wemo leds.
The smartthings hub isnt plugged in batteries out too. Begin with the bulb turned off 2. 1begin with the bulb turned off. Ive reset several bulbs to factory default changed lamps moved the lamp close to the hub all to no avail. Turn on the bulb wait about a second and then turn it off wait 2 seconds turn on the bulb wait about a second and then turn it off wait 2 seconds turn on the bulb wait about a second and then turn it off wait 2 seconds turn on the bulb wait about a second and then turn it off wait 2 seconds. Start with the wemo led on then flip the switch off and wait 1 second before flipping it back on.
Turn the bulb on for 1 second. Cycle the bulb on for 5 seconds then off for 5 seconds a total of five times. Turn the bulb on for 1 second 3. To physically reset the cree connected led bulb. Connected by tcp leds. Unpaired all 4 bedroom cree connected bulbs with the smartthings hub.
Factory reset each cree bulb. Repeat steps 2 and 3 until the bulb momentarily dims about 4 or 5 times 5. For best results we recommend installing the bulb where you can turn the power off at a wall switch. Step 1 install your bulb in a light fixture and turn it on. Good morning i just purchased 6 cree connected 60w bulbs and am unable to pair them with my smartthings hub version 2. This makes all the difference.
Notice on step 2 1 second not 2. To reset the cree connected led bulb turn the bulb off for two 2 seconds then on for one 1 second repeat 4 times. Notice on step 2 1 second not 2 as cree and others have documented. It will only dim for a second signaling that it has been factory reset. Repeat steps 2 and 3 until the bulb momentarily dims about 4 or 5 times 5. Registered hubitat and created a new dasboard.
Turn the bulb off for 2 seconds 4. Went to zigbee pairing mode. Turn the bulb off for 2 seconds.
Gallery of Cree Connected Bulb Reset
